No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Device Management

CloudEngine 8800, 7800, 6800, and 5800 V200R005C10

This document describes the configurations of Device Management, including device status query, hardware management, Information Center Configuration, NTP, Synchronous Ethernet Configuration, Fault Management Configuration, Energy-Saving Management Configuration, Performance Management Configuration, Maintenance Assistant Configuration, and OPS Configuration.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Clock Synchronization Implementation

Clock Synchronization Implementation

Synchronous Ethernet uses physical-layer bit streams to carry and recover frequency information, similar to traditional Synchronous Digital Hierarchy (SDH) synchronization. Figure 5-2 shows principles of synchronous Ethernet:
  • In the transmitting direction: The high-accuracy clock (master clock) traced by Device1 is injected into the PHY chip of an Ethernet interface card on Device1, and the PHY chip places high-accuracy clock information into the serial bit stream of the Ethernet line and sends the serial bit stream so that downstream nodes can obtain the information.
  • In the receiving direction: The PHY chip of an Ethernet interface card on Device2 extracts clock information from the serial bit stream of the Ethernet line and uses the automatic clock source selection algorithm to select a clock source with the highest accuracy and sends the clock source to the system phase-locked loop (PLL). In this case, you can manually or forcibly specify a clock source to be traced. The system PLL then traces the clock source and generates a high-accuracy system clock for each Ethernet interface card.
Figure 5-2 Clock synchronization principles

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100075362

Views: 25472

Downloads: 102

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next