No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - Network Management and Monitoring

CloudEngine 8800, 7800, 6800, and 5800 V200R005C10

This document describes the configurations of Network Management and Monitoring, including SNMP, RMON, NETCONF, OpenFlow, LLDP, NQA, Mirroring, Packet Capture, Packet Trace, Path and Connectivity Detection Configuration, NetStream, sFlow, and iPCA.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring RMON

Configuring RMON

RMON collects traffic statistics and monitors network status on the specified network segment.

Pre-configuration Tasks

Before configuring RMON, complete the following tasks:

  • Configure Ethernet interface parameters.
  • Configure basic SNMP functions.

Configuration Process

The RMON statistics function and RMON alarm function can be configured in any sequence. However, if the alarm variables configured in RMON alarm function are MIB variables defined in the statistics group or history group, the Ethernet statistics function or history statistics function must be configured on the monitored Ethernet interface first. Otherwise, alarm entries cannot be created.

Updated: 2019-04-20

Document ID: EDOC1100075365

Views: 41693

Downloads: 129

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next