No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - Network Management and Monitoring

CloudEngine 8800, 7800, 6800, and 5800 V200R005C10

This document describes the configurations of Network Management and Monitoring, including SNMP, RMON, NETCONF, OpenFlow, LLDP, NQA, Mirroring, Packet Capture, Packet Trace, Path and Connectivity Detection Configuration, NetStream, sFlow, and iPCA.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Applying a NetStream Top Talkers Template to Interfaces

Applying a NetStream Top Talkers Template to Interfaces


NetStream Top Talkers can collect incoming and outgoing traffic statistics separately on an interface. It can collect traffic statistics, sort traffic, and display statistics results only after the NetStream sampling function is enabled on an interface and a NetStream Top Talkers template is applied to the interface.


  1. Run the system-view command to enter the system view.
  2. Run the interface interface-type interface-number command to enter the interface view.
  3. Run the netstream top-talkers talker-name ip { inbound | outbound } command to apply a NetStream Top Talkers template to the interface.

    By default, a NetStream Top Talkers template is not applied to any interface. A maximum of two NetStream Top Talkers templates can be applied to one interface, which are used to collect and sort incoming and outgoing traffic separately.

  4. Run the commit command to commit the configuration.
Updated: 2019-04-20

Document ID: EDOC1100075365

Views: 37024

Downloads: 125

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next