No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Network Management and Monitoring

CloudEngine 8800, 7800, 6800, and 5800 V200R005C10

This document describes the configurations of Network Management and Monitoring, including SNMP, RMON, NETCONF, OpenFlow, LLDP, NQA, Mirroring, Packet Capture, Packet Trace, Path and Connectivity Detection Configuration, NetStream, sFlow, and iPCA.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the NQA Transmission Delay Threshold and Alarm Threshold

Configuring the NQA Transmission Delay Threshold and Alarm Threshold

The statistics about the test packets that exceed the threshold are displayed in the NQA test result. This provides a basis for the network administrators to analyze the operating status of the specified service. The alarm information is sent to the NMS to report the change to the device.

Pre-configuration Tasks

Before configuring the NQA transmission threshold and alarm function, complete the following tasks:

  • Ensure that the device is running properly.
  • Create the NQA test instance and configuring related parameters.

Configuration Process

The configured NQA transmission threshold and alarm threshold help you obtain the statistics about the test packet that exceed the thresholds in the test result. This improves the NQA function and provides an optional configuration for NQA test.

The alarm information can be sent to the NMS only when the routes between the device and NMS are reachable and the related configurations are completed.

NOTE:

For the ICMP Jitter, LSP ping, and LSP Trace test instances, the trap sending conditions cannot be configured.

Perform the following configurations on the NQA client:

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100075365

Views: 37184

Downloads: 125

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next