No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Network Management and Monitoring

CloudEngine 8800, 7800, 6800, and 5800 V200R005C10

This document describes the configurations of Network Management and Monitoring, including SNMP, RMON, NETCONF, OpenFlow, LLDP, NQA, Mirroring, Packet Capture, Packet Trace, Path and Connectivity Detection Configuration, NetStream, sFlow, and iPCA.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying the IPv4 Original Flow Configuration

Verifying the IPv4 Original Flow Configuration

Context

You can run commands to verify the configuration of IPv4 original flow statistics export.

Procedure

  • Run the display forward enp [ slot slot-id ] command to check whether a switch performs NetStream sampling in enhanced mode.

    NOTE:

    Only the CE8868EI, CE8861EI, CE8850-64CQ-EI, CE6875EI, CE6857EI, and CE6865EI support this command.

  • Run the display netstream cache ip origin [ { inbound | outbound } | destination interface interface-type interface-number | destination ip ip-address | destination port port-number | source interface interface-type interface-number | source ip ip-address | source port port-number | protocol protocol-type | tos tos-number ] * slot slot-id [ chip chip-id ] [ verbose ] command to check detailed NetStream statistics on IPv4 original flows on a switch.

    NOTE:

    Only the CE6880EI and CE5880EI support the chip chip-id parameter.

  • Run the display netstream export ip template command to check the exported template information.
  • Run the display netstream statistics ip slot slot-id [ chip chip-id ] command to check NetStream statistics about the IPv4 flows on a switch.

    NOTE:

    Only the CE6880EI and CE5880EI support the chip chip-id parameter.

  • Run the display netstream { all | global | interface interface-type interface-number } command to check the NetStream configuration.
Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100075365

Views: 35201

Downloads: 123

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next