No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - Network Management and Monitoring

CloudEngine 8800, 7800, 6800, and 5800 V200R005C10

This document describes the configurations of Network Management and Monitoring, including SNMP, RMON, NETCONF, OpenFlow, LLDP, NQA, Mirroring, Packet Capture, Packet Trace, Path and Connectivity Detection Configuration, NetStream, sFlow, and iPCA.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Enabling VXLAN Flexible Flow Statistics Collection on an Interface

Enabling VXLAN Flexible Flow Statistics Collection on an Interface


When configuring flexible NetStream, you must enable flow statistics collection and apply a flexible flow statistics template on an interface to ensure that statistics are exported successfully.


  1. Run the system-view command to enter the system view.
  2. Run the interface interface-type interface-number command to enter the interface view.
  3. Run the netstream record record-name vxlan inner-ip command to apply a VXLAN flexible flow statistics template to the interface.

    Each interface can be configured with only one VXLAN flexible flow statistics template. Before changing the VXLAN flexible flow statistics template in the same interface view, run the undo netstream record record-name vxlan inner-ip command to delete the existing configuration.

    After a VXLAN flexible flow statistics template has been applied to the interface, the template configuration cannot be modified or deleted.

  4. Run the netstream { inbound | outbound } ip command to enable NetStream on the interface to collect statistics about IPv4 flows.

    By default, NetStream for IPv4 flows is disabled on interfaces.


    Only the CE6880EI, CE6875EI, CE6870EI , and CE5880EI support outbound VXLAN flexible flow statistics collection.

  5. Run the commit command to commit the configuration.
Updated: 2019-04-20

Document ID: EDOC1100075365

Views: 37176

Downloads: 125

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next