No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Network Management and Monitoring

CloudEngine 8800, 7800, 6800, and 5800 V200R005C10

This document describes the configurations of Network Management and Monitoring, including SNMP, RMON, NETCONF, OpenFlow, LLDP, NQA, Mirroring, Packet Capture, Packet Trace, Path and Connectivity Detection Configuration, NetStream, sFlow, and iPCA.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
RESTCONF-based Configuration and Management

RESTCONF-based Configuration and Management

Devices on a network are usually located in different regions, as shown in Figure 4-6. It is unrealistic for the network administrator to go to each site to configure and manage these devices. And if these network devices come from different manufacturers, each device manufacturer provides a set of independent management methods (for example, using different command lines). NETCONF can be used to facilitate device configuration and management, but NETCONF is complex and cannot adapt to IT O&M tools. In contrast, RESTCONF supports simplified network management and does not require network management tools. It also allows administrator to remotely configure and manage network devices using HTTP and monitor the devices in real time.

Figure 4-6 RESTCONF-based configuration and management

RESTCONF uses the HTTP protocol at the transport layer.

To use RESTCONF to configure and manage the devices shown in Figure 4-6, perform the following operations on the target device to be configured as a RESTCONF server:
  1. Configure the HTTP server function to manage and monitor devices more securely.
  2. Configure the RESTCONF server function.
Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100075365

Views: 40465

Downloads: 127

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next