No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - Network Management and Monitoring

CloudEngine 8800, 7800, 6800, and 5800 V200R005C10

This document describes the configurations of Network Management and Monitoring, including SNMP, RMON, NETCONF, OpenFlow, LLDP, NQA, Mirroring, Packet Capture, Packet Trace, Path and Connectivity Detection Configuration, NetStream, sFlow, and iPCA.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring an MPLS Network to Carry Aggregation Flow Statistics for IPv4 Packets

(Optional) Configuring an MPLS Network to Carry Aggregation Flow Statistics for IPv4 Packets


MPLS IPv4 packet statistics help you understand the usage information about MPLS networks.

Before configuring flow statistics collection for IPv4 packets over an MPLS network, set up an MPLS network by enabling MPLS on the device and interfaces. Select one of the following methods to sample MPLS packets:

  • Sample only the IP packets encapsulated in the MPLS packets.

  • Sample only labels in the MPLS packets.

  • Sample both labels and IP packets encapsulated in the MPLS packets.


Only CE8868EI, CE8861EI, CE8860EI, CE8850EI, CE7855EI, CE7850EI, CE6875EI, CE6870EI, CE6865EI, CE6860EI, CE6857EI, CE6856HI, CE6855HI, CE6851HI, CE6850HI, and CE6850U-HI support statistics collection on MPLS IPv4 flows.

Only the V9 format is supported when an MPLS network carries aggregation flow statistics for IPv4 packets.


  1. Run the system-view command to enter the system view.
  2. Run the netstream mpls-aware { ip-only | label-and-ip | label-only } ip command to configure MPLS packet sampling.

    By default, only the IP packets encapsulated in the MPLS packets are sampled.


    When the MPLS packet sampling method is set to ip-only, you cannot enable MPLS-label aggregation using the netstream aggregation ip command.

  3. Run the commit command to commit the configuration.
Updated: 2019-04-20

Document ID: EDOC1100075365

Views: 41470

Downloads: 127

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next