No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - Network Management and Monitoring

CloudEngine 8800, 7800, 6800, and 5800 V200R005C10

This document describes the configurations of Network Management and Monitoring, including SNMP, RMON, NETCONF, OpenFlow, LLDP, NQA, Mirroring, Packet Capture, Packet Trace, Path and Connectivity Detection Configuration, NetStream, sFlow, and iPCA.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Enabling NetStream Flexible Flow Statistics Collection on an Interface

Enabling NetStream Flexible Flow Statistics Collection on an Interface


When configuring flexible NetStream, you must enable flow statistics collection and apply a flexible flow statistics template on an interface to ensure that statistics are exported successfully.


  1. Run the system-view command to enter the system view.
  2. Run the interface interface-type interface-number command to enter the interface view.
  3. Run the netstream record record-name ip command to apply the IPv4 flexible flow statistics template to the interface.

    Each interface can be configured with only one IPv4 flexible flow statistics template. Before modifying the IPv4 flexible flow statistics template in the same interface view, run the undo netstream record ip command to delete the existing configuration.

    If an IPv4 flexible flow statistics template has been applied to an interface, the template configuration cannot be modified or deleted.

  4. Run the netstream { inbound | outbound } ip command to enable the NetStream function on the interface to collect statistics about IPv4 flows.

    By default, the NetStream function for IPv4 flows is disabled on the interface.

  5. Run the commit command to commit the configuration.
Updated: 2019-04-20

Document ID: EDOC1100075365

Views: 40039

Downloads: 127

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next