No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - Network Management and Monitoring

CloudEngine 8800, 7800, 6800, and 5800 V200R005C10

This document describes the configurations of Network Management and Monitoring, including SNMP, RMON, NETCONF, OpenFlow, LLDP, NQA, Mirroring, Packet Capture, Packet Trace, Path and Connectivity Detection Configuration, NetStream, sFlow, and iPCA.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying the IPv6 Flexible Flow Configuration

Verifying the IPv6 Flexible Flow Configuration


You can run commands to verify that flexible flow statistics exporting has been configured correctly.


  • Run the display forward enp [ slot slot-id ] command to check whether a switch performs NetStream sampling in enhanced mode.


    Only the CE8868EI, CE8861EI, CE8850-64CQ-EI, CE6875EI, CE6857EI, and CE6865EI support this command.

  • Run the display netstream cache ipv6 record record-name [ { inbound | outbound } | destination interface interface-type interface-number | destination ipv6 ipv6-address | destination port port-number | source interface interface-type interface-number | source ipv6 ipv6-address | source port port-number | flowlabel flowlabel | protocol protocol-type | tos tos-number ] * slot slot-id [ chip chip-id ] [ verbose ] command to check detailed NetStream statistics on IPv6 flexible flows on the device.


    Only the CE6880EI and CE5880EI support the chip chip-id parameter.

  • Run the display netstream export ipv6 template command to check the exported template information.
  • Run the display netstream statistics ipv6 slot slot-id [ chip chip-id ] command to check NetStream statistics about IPv6 flows on the device.


    Only the CE6880EI and CE5880EI support the chip chip-id parameter.

  • Run the display netstream { all | global | interface interface-type interface-number } command to check the NetStream configuration.
Updated: 2019-04-20

Document ID: EDOC1100075365

Views: 42084

Downloads: 129

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next