Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the NQA Client to Send Traps When a Probe Fails
Procedure
- Run system-view
The system view is displayed.
- Run nqa test-instance admin-name test-name
The NQA view is displayed.
- Run send-trap probefailure
The NQA client is configured to send traps when a probe fails.
By default, the NQA client sends no trap when a probe fails.
![]()
NOTE: This command cannot be configured when the test-type is set to jitter and trace.
- Run probe-failtimes times
The threshold on the traps sent after the probe fails is configured. The threshold specifies maximum number of continuous probe failures for the NQA test instance.
By default, a trap is sent for each probe failure.
![]()
NOTE: This command cannot be configured when the test-type is set to jitter and trace.
- Run commit
The configuration is committed.
Previous
