No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - Network Management and Monitoring

CloudEngine 8800, 7800, 6800, and 5800 V200R005C10

This document describes the configurations of Network Management and Monitoring, including SNMP, RMON, NETCONF, OpenFlow, LLDP, NQA, Mirroring, Packet Capture, Packet Trace, Path and Connectivity Detection Configuration, NetStream, sFlow, and iPCA.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Application Scenarios for NQA

Application Scenarios for NQA

Performing Network Diagnosis

Networks often encounter such problems as intermittent network disconnections, failure to access websites, slow Internet access, and slow file downloading. When these occur, you can locate the fault by collecting statistics about network devices. These statistics must be provided by the devices.

In the example shown in Figure 8-9, users in different places connect to each other over a VPN. They find, for instance, that the network intermittently disconnects and the connection is slow.

Figure 8-9 Performing network diagnosis

In this situation, you can deploy NQA on PEs to analyze network quality. Perform an ICMP test between the PEs and CEs to check the continuity of the network. After confirming that the network is correctly connected, perform a jitter test to measure network jitter. Then perform the same tests between the PEs. Analyze the test data and the faults that users encounter to locate the source of these faults.

Learning About Network Service Quality

In Figure 8-10, you can perform an NQA test on a switch to obtain statistics about the network operating status. This provides information about network service quality.

Figure 8-10 Learning about network service quality
Updated: 2019-04-20

Document ID: EDOC1100075365

Views: 40994

Downloads: 127

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next