No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - Network Management and Monitoring

CloudEngine 8800, 7800, 6800, and 5800 V200R005C10

This document describes the configurations of Network Management and Monitoring, including SNMP, RMON, NETCONF, OpenFlow, LLDP, NQA, Mirroring, Packet Capture, Packet Trace, Path and Connectivity Detection Configuration, NetStream, sFlow, and iPCA.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying the Hop-by-Hop Performance Measurement Configuration

Verifying the Hop-by-Hop Performance Measurement Configuration


All configurations of hop-by-hop performance measurement are complete.


After IP FPM hop-by-hop performance measurement is configured, you can view the configuration and statistics on the MCP and DCP.


  • Run the display ipfpm mcp command on the MCP to check the configuration and status of MCP.
  • Run the display ipfpm dcp command on the DCP to check the configuration of DCP.
  • Run the display ipfpm statistic-type { loss | oneway-delay | twoway-delay } instance instance-id ach ach-id command on the MCP to check performance statistics of the specified measurement instance in the IP FPM measurement system.
Updated: 2019-04-20

Document ID: EDOC1100075365

Views: 35349

Downloads: 123

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next