No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - Reliability

CloudEngine 8800, 7800, 6800, and 5800 V200R005C10

This document describes the configurations of Reliability, including BFD Configuration, VRRP Configuration, DLDP Configuration, Smart Link and Monitor Link Configuration, EFM Configuration, and CFM Configuration.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Summary of Smart Link and Monitor Link Configuration Tasks

Summary of Smart Link and Monitor Link Configuration Tasks

The switch supports basic functions of Smart Link, load balancing and basic functions of Monitor Link.

Table 5-3 describes the Smart Link and Monitor Link configuration tasks.

Table 5-3 Smart Link and Monitor Link configuration tasks




Configure basic functions of Smart Link

Basic functions of Smart Link can be configured to implement active/standby link redundancy and switching, improving network reliability.

Configuring Basic Functions of Smart Link

Configure load balancing in a Smart Link group

Load balancing improves link efficiency.

Configuring Load Balancing in a Smart Link Group

Configure Monitor Link

Monitor Link monitors an uplink interface on a device and triggers Up/Down state transitions on downlink interfaces in accordance with state changes on the uplink interface. State transitions on the downlink interfaces then trigger link switching of the topology protocol on the downstream device.

Configuring the Uplink and Downlink Interfaces in a Monitor Link Group

Updated: 2019-04-03

Document ID: EDOC1100075366

Views: 21097

Downloads: 62

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next