No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - Virtualization

CloudEngine 8800, 7800, 6800, and 5800 V200R005C10

This document describes the configurations of virtualization, including stack and SVF.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Connecting Parent and Leaf Switches

Connecting Parent and Leaf Switches


After completing SVF configurations, connect the leaf switches to the parent switches to set up an SVF system. If you change the working mode of a leaf switch through commands or change the type of the port that connects a leaf switch to a parent switch, restart the leaf switch to make the modification take effect.

  • One leaf switch can connect to only one SVF system through only one fabric port.

  • During the setup of an SVF system, there is no order between the software configuration and cable connection. You can perform the software configuration and then connect cables; alternatively, connect cables and then perform the software configuration.

Updated: 2020-01-07

Document ID: EDOC1100075367

Views: 12539

Downloads: 80

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next