No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - Virtualization

CloudEngine 8800, 7800, 6800, and 5800 V200R005C10

This document describes the configurations of virtualization, including stack and SVF.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Stack Member Numbering and Interface Naming Rules

Stack Member Numbering and Interface Naming Rules

Member switches in a stack are managed on a per-slot basis and are identified by stack member IDs. When using commands to configure and manage the member switches in a stack, you must specify their stack member IDs. For example, you can run display device slot 2 to view information about a member switch in a stack. Here, 2 is the stack member ID of this switch.

In a stack, interface numbers contain stack member IDs, in the stack member ID/subcard ID/port number format. For example, after a switch joins a stack and is assigned stack member ID 2, the first interface on the switch is numbered 10GE2/0/1.

Updated: 2019-04-03

Document ID: EDOC1100075367

Views: 10864

Downloads: 71

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next