No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Virtualization

CloudEngine 8800, 7800, 6800, and 5800 V200R005C10

This document describes the configurations of virtualization, including stack and SVF.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the Stack MAC Address

Configuring the Stack MAC Address

Context

By default, a stack's MAC address is the MAC address of the master switch elected when the stack is set up. However, the stack MAC address may change after the stack restarts. To retain the stack MAC address, set the stack MAC address to the MAC address of a member switch. The stack then uses the same MAC address every time it restarts.

Procedure

  1. Run the system-view command to enter the system view.
  2. Run the stack command to enter the stack management view.
  3. Run the set system mac-address slot slot-id command to configure the stack MAC address.

    If the current stack MAC address is different from the one configured using this command, the stack MAC address is changed to the configured one immediately after the command is executed.

Translation
Download
Updated: 2019-04-03

Document ID: EDOC1100075367

Views: 9821

Downloads: 69

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next