No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


OceanStor BCManager 6.5.0 eReplication User Guide 02

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Detecting the Remote Management Server (in Remote DR Mode)

Detecting the Remote Management Server (in Remote DR Mode)

If two eReplications are deployed, add a remote management server to the local eReplication. In this manner, the local eReplication can manage local sites that are created on the peer end and added into the local eReplication.


The IP address, port, and user SyncAdmin's password of the remote management server have been obtained.


  1. On the menu bar, select Resources.
  2. In the navigation tree on the left, click .
  3. Configure basic information about the remote management server. Table 5-16 describes related parameters.

    Table 5-16  Parameters related to remote management servers




    IP Address

    The management IPv4 or IPv6 address of a remote eReplication server.



    Communication port between local and remote eReplication management servers.

    [Value range]

    The value ranges from 1 to 65535. The default value is 9443. If the default value is not used during installation, enter the actual port number.


    User that manages the remote eReplication management server. The value is SyncAdmin.



    Login password of user SyncAdmin on the remote eReplication management server.

    The default value is Admin1@BCM.


    Identifier specified to the remote eReplication management server for fast recognition. It is displayed in the navigation tree.

    [Value range]

    • Contains 4 to 32 characters.
    • Contains letters, digits, underscores (_), and hyphens (-), and cannot start with a hyphen (-).


    Remote management server

  4. Click OK.
Updated: 2019-05-21

Document ID: EDOC1100075861

Views: 13808

Downloads: 68

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next