No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

OceanStor BCManager 6.5.0 eReplication User Guide 02

Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
What Can I Do If System Configuration Data Fails to Be Backed Up

What Can I Do If System Configuration Data Fails to Be Backed Up

Symptom

If A FTP server for automatic backup has been configured and no backup data of the FTP server exists at the backup time (2:00 am), the system reports an alarm indicating failed system configuration data backup.

Possible Causes

The parameters for the SSH service of the FTP server are incorrectly configured, causing eReplication failed to connect to the FTP server. As a result, backup fails.

Fault Diagnosis

None

Procedure

    1. Use PuTTY to log in to the management server where the eReplication resides.

      Log in to the management server as user root.

    2. Run the following command to disable the automatic exit of PuTTY due to timeout.

      TMOUT=0

      NOTE:

      After you run this command, the system continues to run when no operation is performed, resulting a risk. For security purposes, you are advised to run exit to exit the system after completing your operations.

    3. Run the following command to go to the path of the configuration tool:

      cd /etc/ssh

    4. Run the following command to open the configuration file:

      vi sshd_config

    5. Press i to enter the edit mode.
    6. Modify the following parameters in the configuration file to be consistent with information in bold.

      PermitRootLogin yes
      PasswordAuthentication yes
      PermitEmptyPasswords no
      ChallengeResponseAuthentication no
      UsePAM yes

    7. Press ESC, enter :wq, save the modification, and exit the VI Editor.
    8. Run the following command to restart the SSHD service:

      service sshd restart

    9. At the next backup time, check whether the alarm is cleared and backup is successful.

      • If yes, no further action is required.
      • If no, contact Huawei technical support.

Related Information

None

Translation
Download
Updated: 2019-05-21

Document ID: EDOC1100075861

Views: 10529

Downloads: 55

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next