No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


OceanStor BCManager 6.5.0 eReplication User Guide 02

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
What Can I Do If the Login Fails Upon a Login Interface Error

What Can I Do If the Login Fails Upon a Login Interface Error


I install the eReplication Server on Linux. A login interface error occurs, and I cannot log in to eReplication.

Possible Causes

After eReplication is configured, the host name corresponding to the IP address obtained from the /etc/hosts Linux host file is inconsistent with that from YaST control center.


  1. Run the yast command to go to the YaST control center, then choose Network Devices > Network Settings.

  2. Select Hostname/DNS, and check and record the correct host name.

  3. Log out of the YaST control center.
  4. Run the vi /etc/hosts command, open the hosts file
  5. Press i to go to the edit mode and edit the hosts file, change the host name in the file to the one obtained in step 2, save the change, and exit.

  6. Re-log in to eReplication.

Suggestion and Summary

For eReplication login failures similar to this condition, you can perform the preceding steps for troubleshooting.

Updated: 2019-05-21

Document ID: EDOC1100075861

Views: 13956

Downloads: 68

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next