No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Event Reference for File

OceanStor Dorado V3 Series V300R002

This document is applicable to OceanStor Dorado5000 V3, Dorado6000 V3 and Dorado18000 V3. This document describes the basic knowledge about the events of storage system in terms of event definition, event level, impact on the system, possible cause, and handling procedure.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
0xF000B0118 ISCSI Link Of Heterogeneous Array Disconnected

0xF000B0118 ISCSI Link Of Heterogeneous Array Disconnected


The iSCSI link of a heterogeneous storage array is interrupted.

Applicable Model

Applicable to all models.



Event Type

Event Level

Automatically Cleared





Impact on the System

The external LUN may have one link only, or go offline.

Possible Causes

  • The cable is not connected or is damaged.
  • The optical module or interface module is faulty.
  • The switch port is faulty, powered off, or its configurations are incorrect.
  • The heterogeneous array is faulty or is powered off.


  1. Check the switch status and configuration. If the cables on the switch are not connected, the optical module on the switch is faulty, the switch is faulty, powered off, or the configuration is incorrect, rectify the fault. If the alarm persists=> Step2.
  2. Check the status of the heterogeneous array. If the cables on the heterogeneous disk array are not connected, the optical module is faulty, the interface module is faulty, or the heterogeneous disk array is faulty or powered off, rectify the fault. If the alarm persists=> Step3.
  3. Collect related information and contact technical support engineers.
Updated: 2019-07-17

Document ID: EDOC1100076630

Views: 23529

Downloads: 5

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next