No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Event Reference for File

OceanStor Dorado V3 Series V300R002

This document is applicable to OceanStor Dorado5000 V3, Dorado6000 V3 and Dorado18000 V3. This document describes the basic knowledge about the events of storage system in terms of event definition, event level, impact on the system, possible cause, and handling procedure.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
0xF000A0129 Failed To Authenticate A Self-Encrypting Disk Key

0xF000A0129 Failed To Authenticate A Self-Encrypting Disk Key

Description

Failed to authenticate a self-encrypting disk key.

Applicable Model

Applicable to all models.

Attribute

ID

Event Type

Event Level

Automatically Cleared

0xF000A0129

Alarm

Major

Yes

Impact on the System

The self-encrypting disk cannot be used on another system.

Possible Causes

  • The link between storage array and the key management server is down.
  • Key management center certificate of the storage array is unavailable.
  • A system error occurs.

Procedure

  1. Check whether the link between the storage array and the key management server is up.

    1. If no, recover the link. After the link is recovered=> Step2.
    2. If yes=> Step2.

  2. Check whether the key management center certificate of the storage array is available.

    1. If yes=> Step3.
    2. If no, import the certificate again. Ensure that the certificate is available=> Step3.

  3. Log in to the controller, enter the CLI in developer mode, and run the "poweroff disk" command to power off the disk. About 1 minute later, run the "poweron disk" command to power on the disk. Wait for 3 minutes and run the "show disk general" command to check whether the health status of the disk is normal.

    1. If yes, check whether the alarm is cleared. If the alarm persists=> Step4.
    2. If no=> Step4.

  4. Collect related information and contact technical support engineers.
Translation
Download
Updated: 2019-07-17

Document ID: EDOC1100076630

Views: 23446

Downloads: 5

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next