No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

FusionStorage 8.0.0 Block Storage DSware Tool Command Reference 03

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Stopping Processes on Nodes

Stopping Processes on Nodes

Run the following command to stop processes on nodes:

sh /opt/dsware/client/bin/dswareTool.sh --op Service name Cmd -subOp StopSingleProcess -controlClusterId controlClusterId -nodeIps nodeIps -processType processType

Parameter

Description

/opt/dsware/client/bin/dswareTool.sh

Specifies an executable program for the tool.

--op Service name Cmd

Self-defined based on the service.

For the replication service, the value is drCmd.

For the dgw service, the value is dgwCmd.

-subOp StopSingleProcess

Stops processes on nodes.

-controlClusterId controlClusterId

Specifies the control cluster ID, for example, 0.

-nodeIps nodeIps

Specifies the IP addresses of the nodes on which processes are to be stopped. This parameter is optional. If it is not specified, processes on all nodes are stopped.

-processType processType

Specifies the DR service type, including ccdb, cm, zk, and dgw.

An example is provided as follows:

dsware@KD182250132182:~> sh /opt/dsware/client/bin/dswareTool.sh --op drCmd -subOp StopSingleProcess -controlClusterId 0 -nodeIps 192.168.35.11 -processType dms
This operation is high risk,please input y to continue:y
[Thu Sep 14 19:22:17 CST 2017] DswareTool operation start.
Enter User Name:admin
Enter Password :
Operation finish successfully. Result Code:0
result    
----------
0         
----------
Total records : 1.
[Thu Sep 14 19:22:26 CST 2017] DswareTool operation end.
Translation
Download
Updated: 2019-08-19

Document ID: EDOC1100081411

Views: 5839

Downloads: 3

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next