No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

FusionStorage 8.0.0 DSware Tool Command Reference 02

Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Modifying the Configuration File

Modifying the Configuration File

Run the following command to change the maximum number of the storage pools:

sh /opt/dsware/client/bin/dswareTool.sh --op Service nameCmd -subOp ChangeAddProcessConfig -parameter max_pool_num:10

Parameter

Description

/opt/dsware/client/bin/dswareTool.sh

Specifies an executable program for the tool.

--op Service nameCmd

Self-defined based on the service.

For the replication service, the value is drCmd.

For the dgw service, the value is dgwCmd.

-subOp ChangeAddProcessConfig

Modifies the configuration file.

-parameter max_pool_num:10

Specifies the maximum number of storage pools.

An example is provided as follows:
dsware@KD182249012053:~> sh /opt/dsware/client/bin/dswareTool.sh --op drCmd -subOp ChangeAddProcessConfig -parameter max_pool_num:10  
[Tue Aug 22 11:36:04 CST 2017] DswareTool operation start.  
Enter User Name:admin  
Enter Password :  
Operation finish successfully. Result Code:0  
[Tue Aug 22 11:36:22 CST 2017] DswareTool operation end.

Run the following command to change the maximum number of HyperMetro pairs:

sh /opt/dsware/client/bin/dswareTool.sh --op Service nameCmd -subOp ChangeAddProcessConfig -parameter max_pair_num:30000

Parameter

Description

/opt/dsware/client/bin/dswareTool.sh

Specifies an executable program for the tool.

--op Service nameCmd

Self-defined based on the service.

For the replication service, the value is drCmd.

For the dgw service, the value is dgwCmd.

-subOp ChangeAddProcessConfig

Modifies the configuration file.

-parameter max_pair_num:30000

Specifies the maximum number of HyperMetro pairs.

An example is provided as follows:
dsware@fsm02:~> sh /opt/dsware/client/bin/dswareTool.sh --op drCmd -subOp ChangeAddProcessConfig -parameter max_pair_num:10000
[Tue Aug 22 11:37:00 CST 2017] DswareTool operation start.
Enter User Name:admin
Enter Password :
Operation finish successfully. Result Code:0
[Tue Aug 22 11:37:19 CST 2017] DswareTool operation end.
NOTE:

The storage pool and HyperMetro pair are names used by the HyperMetro service. Each service can call this interface based on the service requirements.

Translation
Download
Updated: 2019-07-12

Document ID: EDOC1100081411

Views: 4742

Downloads: 3

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next