No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

FusionStorage 8.0.0 DSware Tool Command Reference 02

Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Restoring the Storage Nodes

Restoring the Storage Nodes

This operation is risky. You must confirm whether to continue to execute the command.

Run the following command to restore the storage nodes:

./dswareTool.sh --op restoreStorageNode -ip ip1,ip2,ip3 -p poolId

Parameter

Description

./dswareTool.sh

Specifies an executable program for the tool.

--op restoreStorageNode

Restores the storage nodes.

-ip ip1,ip2,ip3

Specifies the IP addresses of the storage nodes. Multiple restoration operations can be provisioned simultaneously to multiple storage nodes.

-p poolId

Specifies the ID of the storage pool.

An IPv4 example is provided as follows:

dsware@FSM:/opt/dsware/client/bin> ./dswareTool.sh --op restoreStorageNode -ip 192.168.36.28,192.168.36.29,192.168.36.30,192.168.36.31 -p 0
This operation is high risk,please input y to continue:y
[Wed Nov 18 02:38:10 UTC 2015] DswareTool operation start.
Operation finish successfully. Result Code:0
[Wed Nov 18 02:38:12 UTC 2015] DswareTool operation end.

An IPv6 example is provided as follows:

dsware@FSM:/opt/dsware/client/bin> ./dswareTool.sh --op restoreStorageNode -ip 2016:8:40:160:c13:0:169:32,2016:8:40:160:c13:0:169:32,2016:8:40:160:c13:0:169:32 -p 0
This operation is high risk,please input y to continue:y
[Wed Nov 18 02:38:10 UTC 2015] DswareTool operation start.
Operation finish successfully. Result Code:0
[Wed Nov 18 02:38:12 UTC 2015] DswareTool operation end.
Translation
Download
Updated: 2019-07-12

Document ID: EDOC1100081411

Views: 4784

Downloads: 3

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next