No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

FusionStorage 8.0.0 Block Storage DSware Tool Command Reference 03

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Scanning Heterogeneous Storage Media on the Specified Node

Scanning Heterogeneous Storage Media on the Specified Node

Run the following command to scan heterogeneous storage media on the specified node:

The scanning result is saved in the /opt/dsware/client/conf/IsomerMedia.xml file. In this file, the storage media whose vendor value is 0 or phySlot is greater than or equals to 5000 are heterogeneous storage media. Only the heterogeneous storage media with mediaRole as no_use in the file can be changed to isomer_for_dsware. This file is used to allocate slot numbers to heterogeneous storage using the saveIsomerMedia command.

./dswareTool.sh --op scanMediaForIsomer -ip ip1,ip2,ip3,...

Parameter

Description

./dswareTool.sh

Specifies an executable program for the tool.

--op scanMediaForIsomer

Scans heterogeneous storage media on the specified node.

-ip ip1,ip2,ip3,...

Specifies the IP address of the target nodes.

An IPv4 example is provided as follows:

dsware@FSM:/opt/dsware/client/bin> ./dswareTool.sh --op scanMediaForIsomer -ip 192.168.61.31
[Wed Nov 4 14:35:00 CST 2015] DswareTool operation start.
Operation finish successfully. Result Code:0
[Wed Nov 4 14:35:02 CST 2015] DswareTool operation end. 

An IPv6 example is provided as follows:

dsware@FSM:/opt/dsware/client/bin> ./dswareTool.sh --op scanMediaForIsomer -ip 2016:8:40:160:c13:0:169:32
[Wed Nov 4 14:35:00 CST 2015] DswareTool operation start.
Operation finish successfully. Result Code:0
[Wed Nov 4 14:35:02 CST 2015] DswareTool operation end. 

Translation
Download
Updated: 2019-08-19

Document ID: EDOC1100081411

Views: 5934

Downloads: 3

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next