No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


FusionStorage 8.0.0 DSware Tool Command Reference 02

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Setting the Switch for Delivering a Ping Set Only Between Storage Nodes

Setting the Switch for Delivering a Ping Set Only Between Storage Nodes

Run the following command to enable or disable the switch for delivering a ping set only between storage nodes (the default value is close): Enable this switch only when you need to deliver ping packets only between storage nodes.

sh --op checkPoolNodeNetSubHealthOnly -switch open/close



Specifies an executable program for the tool.

--op checkPoolNodeNetSubHealthOnly

Sets the switch for delivering ping sets only between storage nodes.

-switch open/close

Specifies whether to enable or disable the switch. The value can be open (enables the switch) or close (disables the switch).

An example is provided as follows:

dsware@FSM01:/opt/dsware/client/bin> ./ --op checkPoolNodeNetSubHealthOnly -switch open
[Tue Dec 11 17:26:49 CST 2018] DswareTool operation start.
Operation finish successfully. Result Code:0
[Tue Dec 11 17:26:51 CST 2018] DswareTool operation end.

Updated: 2019-07-12

Document ID: EDOC1100081411

Views: 4834

Downloads: 3

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next