No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

FusionStorage 8.0.0 Block Storage Hardware Installation Guide 06

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Connecting a Power Cable for a TaiShan 2280 V2 25-Slot Node

Connecting a Power Cable for a TaiShan 2280 V2 25-Slot Node

This section describes how to connect a power cable for a TaiShan 2280 V2 25-slot node to provide power for the storage node.

TaiShan 2280 V2 25-slot nodes are supported only by FusionStorage 8.0.0.1 or later.

Prerequisites

  • A PDU for the Huawei cabinet or a power distribution device for the third-party cabinet has been prepared.
  • All required tools have been prepared, including Phillips screwdrivers, cable ties, diagonal pliers, and ESD gloves or an ESD wrist strap.
  • A TaiShan 2280 V2 25-slot node has been installed.

Procedure

  1. Wear an ESD wrist strap or ESD gloves.
  2. Insert one end of an AC power cable into the cable connector on the AC PSU of the TaiShan 2280 V2 12-slot node, as shown in Figure 9-13.

    Figure 9-13 Connecting an AC power cable

  3. Use a velcro strap to bundle the power cable onto the handle of the PSU.
  4. Connect the other end of the power cable to the power port of the immediately adjacent PDU and then lock it up, as shown in Figure 9-14.

    To ensure that devices can operate stably, connect power cables on a device supplied by two PSUs to separate PDUs.

    Figure 9-14 Connecting a power cable to a PDU port

  5. Arrange and bind power cables.
Download
Updated: 2019-11-14

Document ID: EDOC1100081415

Views: 8167

Downloads: 15

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next