No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


FusionStorage 8.0.0 Block Storage Security Configuration Guide 05

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Access Control

Access Control

Access control enables you to specify IP addresses that are allowed to access the system through the CLI or DeviceManager. To enable access control, perform the following steps:

  1. Log in to DeviceManager.
  2. Choose Settings > User and Security > Access Control.
  3. Click Add. The Add IP Address/Address Segment dialog box is displayed. Set the IP addresses that are allowed to access the system.

    • IP address segment: If you set Start IP Address and End IP Address, only IP addresses in this segment can access the system.
    • IP address: If you set IP Address, only this IP address can access the system.

  4. Click OK.
  5. If Access Control Status is Disable, click Enable. In the warning dialog box that is displayed, click OK.
Updated: 2019-10-18

Document ID: EDOC1100081422

Views: 1529

Downloads: 3

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next