No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

FusionStorage 8.0.0 Software Installation Guide 02

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Using PuTTY to Log In to a Node in Key Pair Authentication Mode

Using PuTTY to Log In to a Node in Key Pair Authentication Mode

Scenarios

After security hardening is performed on the SSH login mode for nodes in the system, SSH-based password authentication is disabled for login. This section describes how to use PuTTY and the required private key for authentication to log in to a target node.

Prerequisites

  • Security hardening has been performed on the SSH login mode for the target node by:
    • Enabling the SSH key pair authentication mode and configuring the public key certificate on the node.
    • Disabling the SSH-based password authentication.
  • You have obtained the private key certificate matching the public key certificate.

    If the private key certificate is encrypted, you also need to obtain its password.

Procedure

  1. Check whether PuTTY on the local PC has been used to log in to a node in key pair authentication mode.

    • If yes, go to 7.
    • If no, or you are uncertain about it, go to 2.

  2. Run PuTTY and enter the IP address of the target node and the SSH port (default value: 22).
  3. In the Category area in the left pane, choose Connection > SSH > Auth.

    The SSH authentication configuration page is displayed.

  4. Click Browse. In the dialog box that is displayed, select the obtained private key certificate and click Open. The private key certificate file name is *.ppk, as shown in Figure 5-6.

    Figure 5-6 Configuring the private key certificate

  5. In the Category area in the left pane, select Session.
  6. To facilitate subsequent access, create a customized session in Saved Sessions and click Save, as shown in Figure 5-7.

    After this step is performed, go to 8.
    Figure 5-7 Saving a session

  7. Select a saved session and click Load to load the session.
  8. Click Open to open the session.
  9. Enter the user name for logging in to the target node as prompted.

    If the private key certificate is encrypted, enter its password as prompted.

Translation
Download
Updated: 2019-07-12

Document ID: EDOC1100081424

Views: 1829

Downloads: 8

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next