Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Support-mounted Installation
Prerequisites
Prepare M6 stainless bolt assemblies (including flat washers, spring washers, and M6 bolts) with appropriate lengths as well as matched flat washers and nuts based on the support specifications.
Procedure
- Determine the hole positions based on the marking-off template, and then mark the hole positions using a marker.Figure 4-12 Determining hole positions
- Drill holes using a hammer drill.
You are advised to apply anti-rust paint on the hole positions for protection.
Figure 4-13 Drilling holes - Secure the mounting bracket.Figure 4-14 Securing the mounting bracket
- Install the SUN2000 onto the mounting bracket.
- Tighten the bolt assembly.Figure 4-15 Installing the SUN2000
- (Optional) Install the anti-theft lock.
- Prepare an anti-theft lock suitable for the lock hole diameter (Ф8 mm) by yourself.
- An outdoor waterproof lock is recommended.
- Keep the key to the anti-theft lock safe.
Figure 4-16 Installing the anti-theft lock
