No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

SUN2000-(175KTL-H0, 185KTL-INH0, 185KTL-H1) User Manual

This document describes the SUN2000-175KTL-H0,SUN2000-185KTL-INH0, and SUN2000-185KTL-H1 in terms of their installation, electrical connections, commissioning, maintenance, and troubleshooting. BOM number: 01074671, 01074684, 01074687
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Replacing a Fan

Replacing a Fan

  • Before replacing a fan, power off the inverter.
  • When replacing a fan, use insulation tools and wear personal protective devices.
NOTE:

If the fan tray gets stuck when being pulled or pushed, slightly lift it.

  1. Remove the screw on the fan tray and save it. Pull out the fan tray until the fan baffle plate aligns with the inverter chassis.

    Figure 8-2 Pulling out fan tray (1)

  2. Remove the cable ties shared by the cables, unscrew the connectors, and disconnect the cables.

    Figure 8-3 Disconnecting cables

  3. Pull out the fan tray.

    Figure 8-4 Pulling out fan tray (2)

  4. Remove cable ties from the faulty fan.

    • FAN 1 Faulty
      Figure 8-5 Removing the FAN 1 cable ties
    • FAN 2 Faulty
      Figure 8-6 Removing the FAN 2 cable ties
    • FAN 3 Faulty
      Figure 8-7 Removing the FAN 3 cable ties

  5. Remove the faulty fan (FAN 1 is used as an example).

    Figure 8-8 Removing the fan

  6. Install the new fan (FAN 1 is used as an example).

    Figure 8-9 Installing a new fan

  7. Bind the fan cables.

    • Binding positions for fan 1
      Figure 8-10 Binding the FAN 1 cables
    • Binding positions for fan 2
      Figure 8-11 Binding the FAN 2 cables
    • Binding positions for fan 3
      Figure 8-12 Binding the FAN 3 cables

  8. Push the fan tray into the slot until the fan baffle plate aligns with the inverter chassis.

    Figure 8-13 Pushing the fan tray in

  9. Connect the cables correctly according to the cable labels and bind the cables.

    Figure 8-14 Reconnecting and binding the cables

  10. Push the fan tray into the slot and tighten the screw.

    Figure 8-15 Reinstalling the fan tray

Download
Updated: 2019-09-21

Document ID: EDOC1100083285

Views: 7398

Downloads: 614

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next