No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade
EG8245Q Quick Start for QR code 03

This document shows you the EG8245Q, and how to install it.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Placing the Device

Placing the Device

  • Do not install the ONT outdoors or in an outdoor cabinet.
  • The ONT can be mounted onto a wall or placed on a desk. Do not install the ONT in other modes, such as ceiling.
  • Keep 10 cm clearance on all sides to ensure adequate ventilation.
  • It is recommended that the computer and ONT be put far away from electric appliances that generate strong magnetic or electric fields, such as microwave ovens.

Mounting an ONT on the desk

The figure below shows an ONT that is horizontally placed on a desk.

The appearance shown in this document may be different from the actual appearance of the product. The actual product prevails.

Mounting an ONT onto the wall

  1. Mark two positions with the same spacing as that between the two mounting holes of the ONT using a marker on a wall.
  2. Select a proper drill bit according to the outer diameter of the screws. Use a hammer drill to drill the marked positions on the wall. Then clean the holes and install two expansion bolts.
  3. Use a screwdriver to fasten the screws into the expansion bolts, reserving 5 mm ends out of the wall, and mount the ONT onto the screws.

It is recommended that the screw be about 4 mm in diameter and longer than 20 mm.

Download
Updated: 2020-03-06

Document ID: EDOC1100086672

Views: 713

Downloads: 23

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Share
Previous Next