No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


SUN2000-(100KTL, 110KTL, 125KTL) Series User Manual

This document describes the SUN2000-125KTL-M0,SUN2000-110KTL-M0,SUN2000-100KTL-M0,SUN2000-100KTL-M1 and SUN2000-100KTL-INM0 in terms of its installation, electrical connections, commissioning, maintenance, and troubleshooting. BOM number: 01074693, 01074694, 01074695, 01074695-001 and 01074695-002.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Installing the Power Cable of the Tracking System

(Optional) Installing the Power Cable of the Tracking System


  • The tracking system obtains power from the AC three-phase power grid. The rated voltage of the power supply is the rated output voltage of the solar inverter.
  • Keep inflammable materials away from the power cable.
  • The power cable must be protected with a conduit to prevent short circuits caused by insulation layer damage.
  • Connect the power cable of the tracking system before the AC output power cable. Otherwise, reworking will be caused.


  1. Prepare a cable.
  2. Remove the corresponding rubber rings.
  3. Connect the power cable of the tracking system.

    Figure 5-11 Connecting the power cable of the tracking system

Updated: 2019-12-25

Document ID: EDOC1100087908

Views: 5536

Downloads: 667

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next