No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.

SUN2000-(100KTL, 110KTL, 125KTL) Series User Manual

This document describes the SUN2000-125KTL-M0,SUN2000-110KTL-M0,SUN2000-100KTL-M0,SUN2000-100KTL-M1 and SUN2000-100KTL-INM0 in terms of its installation, electrical connections, commissioning, maintenance, and troubleshooting. BOM number: 01074693, 01074694, 01074695, 01074695-001 and 01074695-002.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Mechanical Safety

Mechanical Safety

Using Ladders

  • Use wooden or fiberglass ladders when you need to perform live working at heights.
  • When a step ladder is used, ensure that the pull ropes are secured and the ladder is held firm.
  • Before using a ladder, check that it is intact and confirm its load bearing capacity. Do not overload it.
  • Ensure that the wider end of the ladder is at the bottom, or protective measures have been taken at the bottom to prevent the ladder from sliding.
  • Ensure that the ladder is securely positioned. The recommended angle for a ladder against the floor is 75 degrees, as shown in the following figure. An angle rule can be used to measure the angle.

  • When climbing a ladder, take the following precautions to reduce risks and ensure safety:
  • Keep your body steady.
  • Do not climb higher than the fourth rung of the ladder from the top.
  • Ensure that your body's center of gravity does not shift outside the legs of the ladder.

Drilling Holes

  • When drilling holes into a wall or floor, observe the following safety precautions: Wear goggles and protective gloves when drilling holes.
  • When drilling holes, protect the equipment from shavings. After drilling, clean up any shavings that have accumulated inside or outside the equipment.

Moving Heavy Objects

  • Be cautious to avoid injury when moving heavy objects.

  • When moving the equipment by hand, wear protective gloves to prevent injuries.
Updated: 2020-02-27

Document ID: EDOC1100087908

Views: 12665

Downloads: 1448

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next