No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

SUN2000-(100KTL, 110KTL, 125KTL) Series User Manual

This document describes the SUN2000-125KTL-M0,SUN2000-110KTL-M0,SUN2000-100KTL-M0,SUN2000-100KTL-M1 and SUN2000-100KTL-INM0 in terms of its installation, electrical connections, commissioning, maintenance, and troubleshooting. BOM number: 01074693, 01074694, 01074695, 01074695-001 and 01074695-002.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Replacing a Fan

Replacing a Fan

  • Before replacing a fan, power off the inverter.
  • When replacing a fan, use insulation tools and wear personal protective devices.

If the fan tray gets stuck when being pulled or pushed, slightly lift it.

  1. Remove the screw on the fan tray and save it. Pull out the fan tray until the fan baffle plate aligns with the inverter chassis.

    Figure 8-3 Pulling out fan tray (1)

  2. Remove the cable ties shared by the cables, unscrew the connectors, and disconnect the cables.

    Figure 8-4 Disconnecting cables

  3. Pull out the fan tray.

    Figure 8-5 Pulling out fan tray (2)

  4. Remove cable ties from the faulty fan.

    • FAN 1 Faulty
      Figure 8-6 Removing the FAN 1 cable ties
    • FAN 2 Faulty
      Figure 8-7 Removing the FAN 2 cable ties
    • FAN 3 Faulty
      Figure 8-8 Removing the FAN 3 cable ties

  5. Remove the faulty fan (FAN 1 is used as an example).

    Figure 8-9 Removing the fan

  6. Install the new fan (FAN 1 is used as an example).

    Figure 8-10 Installing a new fan

  7. Bind the fan cables.

    • Binding positions for fan 1
      Figure 8-11 Binding the FAN 1 cables
    • Binding positions for fan 2
      Figure 8-12 Binding the FAN 2 cables
    • Binding positions for fan 3
      Figure 8-13 Binding the FAN 3 cables

  8. Push the fan tray into the slot until the fan baffle plate aligns with the inverter chassis.

    Figure 8-14 Pushing the fan tray in

  9. Connect the cables correctly according to the cable labels and bind the cables.

    Figure 8-15 Reconnecting and binding the cables

  10. Push the fan tray into the slot and tighten the screw.

    Figure 8-16 Reinstalling the fan tray

Translation
Download
Updated: 2019-12-25

Document ID: EDOC1100087908

Views: 5620

Downloads: 669

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Share
Previous Next