No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

SUN2000-(100KTL, 110KTL, 125KTL) Series User Manual

This document describes the SUN2000-125KTL-M0,SUN2000-110KTL-M0,SUN2000-100KTL-M0,SUN2000-100KTL-M1 and SUN2000-100KTL-INM0 in terms of its installation, electrical connections, commissioning, maintenance, and troubleshooting. BOM number: 01074693, 01074694, 01074695, 01074695-001 and 01074695-002.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Solar Inverter Storage

Solar Inverter Storage

The following requirements should be met if the solar inverter is not put into use immediately:

  • Do not remove the packing materials, and check the packing materials regularly (recommended: every three months). If any rodent bites are found, replace the packing materials immediately. If the solar inverter is unpacked but not put into use immediately, put it inside the original package with the desiccant bag, and seal it using tape.
  • The ambient temperature and humidity should be suitable for the storage. The air must not contain corrosive or flammable gases.
    Figure 3-1 Storage temperature and humidity
  • The solar inverter should be stored in a clean and dry place and be protected from dust and water vapor corrosion. The solar inverter must be protected against rain and water.
  • Do not tilt the package or place it upside down.
  • To avoid personal injury or device damage, stack inverters with caution to prevent them from falling over.
    Figure 3-2 Maximum number of pile-up layers allowed
  • If the solar inverter has been stored for more than two years, it must be checked and tested by professionals before being put into use.
Translation
Download
Updated: 2019-12-25

Document ID: EDOC1100087908

Views: 5553

Downloads: 667

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Share
Previous Next