No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


SUN2000-(100KTL, 110KTL, 125KTL) Series User Manual

This document describes the SUN2000-125KTL-M0,SUN2000-110KTL-M0,SUN2000-100KTL-M0,SUN2000-100KTL-M1 and SUN2000-100KTL-INM0 in terms of its installation, electrical connections, commissioning, maintenance, and troubleshooting. BOM number: 01074693, 01074694, 01074695, 01074695-001 and 01074695-002.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Wall-mounted Installation

Wall-mounted Installation


You have prepared expansion bolts. M12x60 stainless steel expansion bolts are recommended.


  1. Determine the positions for drilling holes using the mounting bracket. Level the positions of mounting holes using a bubble or digital level, and mark the positions with a marker.
  2. Drill holes using a hammer drill and install expansion bolts.

    Avoid drilling holes in the position of the wall with water pipes and power cables buried inside.

    • To prevent dust inhalation or contact with eyes, wear safety goggles and an anti-dust respirator when drilling holes.
    • Clean up any dust in and around the holes using a vacuum cleaner and measure the distance between holes. If the holes are inaccurately positioned, drill a new set of holes.
    • Level the head of the expansion sleeve with the concrete wall after removing the bolt, spring washer, and flat washer. Otherwise, the mounting bracket will not be securely installed on the wall.

  3. Secure the mounting bracket.

    Figure 4-11 Installing the mounting bracket

Updated: 2019-12-25

Document ID: EDOC1100087908

Views: 5826

Downloads: 693

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next