Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the LOM PXE
Scenarios
Configure the PXE function for an LOM on a server using BIOS. The PXE enables the server to boot over the network.
Procedure
- Access the BIOS. For details, see Accessing the BIOS.
- Press ← or → to switch to the Advanced screen shown in Figure 3-16, which is an example screen for TaiShan 200 (model 2280).
- Choose LOM Configuration > PXE Configuration and press Enter.The PXE Configuration screen is displayed, as shown in Figure 3-17.
The PXE Configuration screen may vary according to the server.
- Configure the PXE function.
- Select the network port such as PXE1 Configuration, and press Enter.
- In the dialog box that is displayed, select Enable and press Enter.
- Select a network protocol for PXE boot.
- Select PXE Boot Capability and press Enter.
- In the dialog box that is displayed, select a network protocol that needs to be supported.
- UEFI: IPv4
- UEFI: IPv6
- UEFI: IPv4/IPv6
- HTTPS: IPv4
- HTTPS: IPv6
- HTTPS: IPv4/IPv6
The value of this parameter varies according to the server model or BIOS version. For details, see LOM Configuration.
- Press F10.
The system displays the "Save configuration changes and exit?" dialog box.
- Select Yes and press Enter.
The server automatically restarts for the settings to take effect.
