- About This Document
Safety Information
Product Description
- Technical Specifications
Installation
Installation Requirements
Installation Preparations
- Unpacking and Acceptance
Installing the Indoor Unit
Installing the Outdoor Unit
(Optional) Installing a Low Temperature Component
Installing a Water-Cooled Module
Installing Pipes
- Notices for Laying Pipes
- Welding Indoor Unit Pipes
- Welding Outdoor Unit Pipes
- (Optional) Welding Pipes for the Low Temperature Component
- Welding the Water Cooling Module
- Installing Cooling Water pipes for the Water-Cooled Module
- Installing Drainpipes
- (Optional) Installing the Humidifier Water Inlet Pipe
- Leakage Test with Nitrogen for Refrigerant Pipes
- (Optional) Leakage Test with Water for the Water-Cooled Module
Installing Cables
- Cable Connection Precautions
- Installing the Equipotential Ground Cable
- Installing Power Cables for the Indoor Unit
- Installing the Outdoor Unit Power Cable
- (Optional) Installing Power Cables for the Low Temperature Component
- (Optional) Installing Outdoor Unit Communications Cables
- (Optional) Installing T/H Sensors Outside a Cabinet and Cables
- (Optional) Connecting Teamwork and Monitoring Communications Cables
Installation Verification
Power-On Commissioning
WebUI
Maintenance
- Alarm Reference
- Troubleshooting
Parts Replacement
- Replacing an Air Filter
- Replacing an Indoor Fan
- Replacing an Outdoor Fan
- Replacing a Differential Pressure Switch
- Replacing a Pressure Switch or Pressure Sensor
- Replacing a Compressor (Threaded Connection)
- Replacing a Compressor (Welding)
- Replacing a Filter Dryer (Threaded Connection)
- Replacing a Filter Dryer (Welding)
- Replacing a Liquid Level Detector
- Replacing a Condensate Pump
- Replacing a Wet Film Humidifier
- Replacing a Display Module
- Replacing a Main Control Module or PSU
- Replacing an Electric Heater
FAQ
- How Do I Issue a Start/Shutdown Command?
Operations with a USB Flash Drive
Display Module Screen Operations
- How Do I Set LAN Parameters?
- How Do I Query Temperature and Humidity Curves?
- Querying Logs
- How Do I View Component Status?
- Querying System Parameters
- Querying Version Details
- How Do I Check Teamwork Control Information?
- How Do I Mute or Silence a Buzzer?
- How Can I Handle Active Alarms?
- How Do I Delete Historical Alarms?
- How Do I Clear Component Runtime?
- How to Calibrate a Sensor
- How Do I Change the Password?
- How to Set Alarm Parameters
- How to Commission Single Component
- How Do I Query the Setting of a Parameter Before Change?
WebUI Operations
- Power Cable Filter for an Outdoor Unit
- Indoor Unit Cooling Component Layout
Outdoor Unit Electric Control Box Layout
Base Drawing
Electrical Conceptual Diagram
- Acronyms and Abbreviations