Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Outdoor Unit Base Drawings
- It is recommended that the base be made of cost-effective angle steel of 45 mm x 45 mm x 4 mm.
- It is recommended that the base be higher than 100 mm.
- The base is a welded structure. Ensure that the installation surface is polished and the base is rust-proof.
When preparing the base, pay attention to the following points:
- Angle, square, or channel steel with a width of 45–60 mm and a thickness of 4–5 mm is recommended.
- If the angle steel width is less than or equal to 60 mm, there is no need to consider measures for avoiding blockage.
- If the angle steel width is greater than 60 mm, the base interferes with the hole for routing cables. In this case, cut holes on the angle steel to avoid blockage.
- Install shock pads between the base and the unit. The shock pads should be made of EPDM rubber and 5 mm thick.
- Control welding errors during the manufacturing process. If welding errors are large, the base will be unusable after welding.
- The base height can be adjusted based on site requirements.