Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
How Do I Issue a Start/Shutdown Command?
You can use the start/shutdown signal over the smart cooling product LCD, ECC WebUI, or NetEco WebUI, or hardware port to start or shut down the smart cooling product.
Scenario |
Operation |
Start/Shutdown Signal Status - LCD/ECC/NetEco WebUI |
Start/Shutdown Signal Status - Hardware Port |
|---|---|---|---|
If the equipment is started, issue a shutdown command to shut down the equipment. |
Method 1: Set the start/shutdown signal to shutdown on the smart cooling product LCD, ECC WebUI, or NetEco WebUI. |
Shutdown |
Start |
Method 2: Connect the remote start/shutdown dry contacts of the hardware port. |
Start |
Shutdown |
|
If the equipment is shut down, issue a start command to start the equipment. |
|
Start |
Start |
NOTE:
|
|||
Figure 12-1 Start/Shutdown over the LCD
![]()
Figure 12-2 Start/Shutdown over the ECC WebUI
![]()
Figure 12-3 Start/Shutdown over the NetEco WebUI
![]()
Figure 12-4 Start/Shutdown over the hardware port
![]()
