Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Water-Cooled Module
Components
The NetCol500 water-cooled module consists of an electric control box, an water valve actuator, and a rack. The following describes the components and configuration.
Figure 2-9 Water-cooled module components
![]()
(1) Water valve actuator |
(2) Water return pipe |
(3) Water supply pipe |
(4) Negative temperature coefficient (NTC) sensor |
(5) Liquid pipe |
(6) Electric control box |
(7) Cooling water side needle valve |
(8) Gas pipe |
(9) Refrigerant side needle valve |
(10) Safety valve |
Features
- The water valve is pre-integrated to save onsite installation time.
- The water-cooled module can be installed in stack mode to maximize the installation space and reduce the footprint.
- The water-cooled module uses cooling water for heat exchange to improve the heat exchange efficiency and improve the energy efficiency of the entire system to 4.0 COP.