Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Indoor Unit Base Drawing
Figure D-1 Base drawing (unit: mm)
![]()
- You are advised to use angle steel or channel steel. Thickness of 3 mm to 5 mm is recommended.
- Control welding errors during the manufacturing process. If welding errors are large, the base will be unusable after welding.
- The M12 bolt used for securing the cabinet to its base must be at least 80 mm long.
- The base bearing capacity must be at least 2 t.
- Connect adjacent bases in parallel using bolts. Ensure that each base is secured to the ground through at least four corners.