Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
QSFP28-100G-DR
Table 8-72 QSFP28-100G-DR specifications
| Item | Value |
|---|---|
| Basic Information | |
| Module name | QSFP28-100G-DR |
| Part Number | 02312VSP |
| Model | QSFP28-100G-DR |
| Form factor | QSFP28 |
| Application standard/Type | 100GBase-DR |
| Connector type | LC |
| Optical fiber type | SMF |
| Type of the end face of the fiber ceramic ferrule | PC or UPC |
| Working case temperature [°C (°F)] | 0°C to 70°C (32°F to 158°F) |
| DDM options | Supported |
| Transmission rate [bit/s] | 100Gbit/s |
| Target transmission distance [km] | Single-mode fiber (G.652) (with diameter of 9 μm): 500m |
| Transmitter Optical Characteristics | |
| Center wavelength [nm] | 1311 nm |
| Maximum Tx optical power (AVG) [dBm] | 4 dBm |
| Minimum Tx optical power (AVG) [dBm] | -2.9 dBm |
| Maximum Tx optical power (OMA) [dBm] | 4.2 dBm |
| Minimum Tx optical power (OMA) [dBm] | -0.8 dBm |
| Minimum extinction ratio [dB] | 3.5 dB |
| Receiver Optical Characteristics | |
| Rx sensitivity (AVG) [dBm] | -5.9 dBm |
| Rx sensitivity (OMA) [dBm] | Max(-3.9,SECQ-5.3) |
| Overload power (AVG) [dBm] | 4 dBm |
- Version support: V200R020C10 and later versions
- A port that has a QSFP28-100G-DR optical module installed cannot be used for stack connection.
- Before installing a QSFP28-100G-DR optical module on a port, you need to disable the FEC function on the port. For example, if the RS-FEC function is enabled on a port that has a QSFP28-100G-DR optical module installed, the port status will become Down (Transceiver type mismatch).