Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
CloudEngine 16808 DC PEM
Overview
The CloudEngine 16808 DC PEM connects the CloudEngine 16808 to DC power sources. The PEM is pre-installed by default, and cannot be removed, installed, or replaced onsite.
The PEM is integrated into the chassis and does not need to be configured onsite. Do not remove or install the PEM onsite.
Appearance
Figure 4-17 Appearance of the CloudEngine 16808 DC PEM
![]()
Panel
Figure 4-18 Terminal blocks on the CloudEngine 16808 DC PEM
![]()
Table 4-15 describes the location mapping between CloudEngine 16808 PEM terminal blocks and power modules.
Table 4-15 Location mapping between PEM terminal blocks and power modules
PEM Terminal Block |
A1/B1 |
A2/B2 |
A3/B3 |
... |
A9/B9 |
A10/B10 |
|---|---|---|---|---|---|---|
Power Module |
1 |
2 |
3 |
... |
9 |
10 |
Table 4-16 Terminal block description
Name |
Description |
Power Cable Terminal |
|---|---|---|
NEG (-) |
-48 V/-60 V terminal block |
|
RTN (+) |
BGND terminal block |