Wireless Access Controller (AC and Fit AP) V200R019C00 CLI-based Configuration Guide
Network Management and Monitoring Configuration Guide
- SNMP Configuration
SNMP is a standard network management protocol widely used on TCP/IP networks. It uses a central computer (a network management station) that runs network management software to manage network elements. There are three SNMP versions, SNMPv1, SNMPv2c, and SNMPv3. You can choose to configure one or more versions if needed. - RMON Configuration
Remote Network Monitoring (RMON), defined by IETF, is a widely used network management protocol. It provides packet statistics and alarm functions for Ethernet interfaces. The management devices use RMON to remotely monitor and manage network elements. RMON2 is an enhancement of RMON. Currently, the device can collect and analyze statistics on IP packets. - Mirroring Configuration
- Performance Management Configuration
This chapter describes how to configure performance management to collect and count system performance indicators to help you analyze system running status. - LLDP Configuration
The Link Layer Discovery Protocol (LLDP) allows you to obtain details about the network topology, changes in the topology, and detect incorrect configurations on the network. - Packet Obtaining Configuration
This chapter describes the concept and configuration of the packet obtaining function. - Service Diagnosis Configuration
- NetStream Configuration
This chapter describes how to configure NetStream. NetStream is a technology that collects and exports flow statistics. It allows fine-grained management, for example, department charging, traffic monitoring and analysis. - WLAN Access Site Information Management Configuration
- Third-Party Data Collection Configuration
- KPI Information Report Configuration
Document ID：EDOC1100096325
Views：2177432
Downloads：3722
Average rating：5.0Points