No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

SmartLogger3000 User Manual

This document describes the SmartLogger3000 and SmartModule1000A01 in terms of installation, electrical connections, system operation, maintenance, and troubleshooting. BOM number: 02312SCU, 02312SCU-001, 02312SCU-002, 02312SCU-003, 02312SCU-004, 02312SCU-005, 02312SCU-006, 02312SCU-007, 02312SCU-008, 02312SCU-009, 02312SCU-010, 02312SGF, 02312SGG, 02312SGK and 02312SGJ.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Mechanical Safety

Mechanical Safety

Using Ladders

  • Use wooden or fiberglass ladders when you need to perform live working at heights.
  • When a step ladder is used, ensure that the pull ropes are secured and the ladder is held firm.
  • Before using a ladder, check that it is intact and confirm its load bearing capacity. Do not overload it.
  • Ensure that the wider end of the ladder is at the bottom, or protective measures have been taken at the bottom to prevent the ladder from sliding.
  • Ensure that the ladder is securely positioned. The recommended angle for a ladder against the floor is 75 degrees, as shown in the following figure. An angle rule can be used to measure the angle.

  • When climbing a ladder, take the following precautions to reduce risks and ensure safety:
  • Keep your body steady.
  • Do not climb higher than the fourth rung of the ladder from the top.
  • Ensure that your body's center of gravity does not shift outside the legs of the ladder.

Drilling Holes

  • When drilling holes into a wall or floor, observe the following safety precautions: Wear goggles and protective gloves when drilling holes.
  • When drilling holes, protect the equipment from shavings. After drilling, clean up any shavings that have accumulated inside or outside the equipment.

Moving Heavy Objects

  • Be cautious to avoid injury when moving heavy objects.

  • When moving the equipment by hand, wear protective gloves to prevent injuries.
Translation
Download
Updated: 2020-02-21

Document ID: EDOC1100108365

Views: 7216

Downloads: 1263

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Share
Previous Next