Exporting Configuration Files from the SUN2000 App
Do not power off the SmartLogger3000 when exporting all configuration files.
- Before replacing the SmartLogger, export its configuration files to a USB flash drive.
- Insert the USB flash drive into the USB port at the bottom of the SmartLogger3000.
- Run the SUN2000 app and select a connection mode. On the operation screen, tap Manual connection, and select WLAN. The initial name of the WLAN hotspot is Logger-SmartLogger SN. You can view the device SN on the SmartLogger3000 label.
Use the initial password Changeme of the WLAN hotspot for the first login and change it immediately after login. To ensure account security, protect the password by changing it periodically, and keep it secure. Your password might be stolen or cracked if it is left unchanged for extended periods. If a password is lost, devices cannot be accessed. In these cases, the Company shall not be liable for any loss caused to the plant.
- After connecting the WLAN, log in to the device and access the main menu screen.
- When you log in to the device for the first time, set the login password. To ensure account security, protect the password by changing it periodically, and keep it secure. Your password might be stolen or cracked if it is left unchanged for extended periods. If a password is lost, devices cannot be accessed. In these cases, the Company shall not be liable for any loss caused to the plant.
- You will be locked out for 10 minutes after five consecutive failed password attempts (the interval between two consecutive entries is less than 2 minutes).
- Choose Maintenance > Export All Files, set Encryption password of the exported file, and tap Confirm to export the configuration files.
- After the export is complete, tap OK and remove the USB flash drive.
- Power off the SmartLogger, remove its cables, and label the cables.
- Install a new SmartLogger, reconnect the cables, and power on the SmartLogger.
- Run the SUN2000 app, log in to the new device, and import the configuration files.
- Insert the USB flash drive into the USB port at the bottom of the new SmartLogger3000.
- Start the SUN2000 app and log in to the new device. On the operation screen, tap Manual connection, and select WLAN. The initial name of the WLAN hotspot is Logger-SmartLogger SN. You can view the device SN on the SmartLogger3000 label.
Use the initial password Changeme of the WLAN hotspot for the first login and change it immediately after login. To ensure account security, protect the password by changing it periodically, and keep it secure. Your password might be stolen or cracked if it is left unchanged for extended periods. If a password is lost, devices cannot be accessed. In these cases, the Company shall not be liable for any loss caused to the plant.
- After connecting the WLAN, log in to the device and access the main menu screen.
- When you log in to the device for the first time, set the login password. To ensure account security, protect the password by changing it periodically, and keep it secure. Your password might be stolen or cracked if it is left unchanged for extended periods. If a password is lost, devices cannot be accessed. In these cases, the Company shall not be liable for any loss caused to the plant.
- You will be locked out for 10 minutes after five consecutive failed password attempts (the interval between two consecutive entries is less than 2 minutes).
- Choose Maintenance > Import All Files, enter Decryption password of the imported file, and tap Confirm to import the configuration files.
- After the import is complete, tap OK and remove the USB flash drive.
- After the import is successful, the SmartLogger restarts for the configuration files to take effect. Ensure that the parameters on the settings tab page and the parameters for the built-in MBUS are correctly set.
