No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


SmartLogger3000 User Manual

This document describes the SmartLogger3000 and SmartModule1000A01 in terms of installation, electrical connections, system operation, maintenance, and troubleshooting. BOM number: 02312SCU, 02312SCU-001, 02312SCU-002, 02312SCU-003, 02312SCU-004, 02312SCU-005, 02312SCU-006, 02312SCU-007, 02312SCU-008, 02312SCU-009, 02312SCU-010, 02312SGF, 02312SGG, 02312SGK and 02312SGJ.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Setting Parameters for a Custom Device

Setting Parameters for a Custom Device


The SmartLogger can connect to third-party devices supporting the Modbus-RTU protocol, such as the transformer substation and EMI. The protocol information points vary depending on vendors. Therefore, you need to configure a protocol information file in .cfg format and import the file into the SmartLogger for successfully connecting to a custom device.

The supported device types are custom device 1 to custom device 10. The corresponding configuration file names are modbus_equip_custom_1.cfg to modbus_equip_custom_10.cfg. Multiple devices of the same type can be connected.


  1. Configure a protocol information point file in .cfg format and import the file to the SmartLogger.

    Figure 6-36 Importing configuration

  2. Set access parameters and click Add Devices.

    Figure 6-37 Setting access parameters



    Device Type

    The value can be Custom Device 1 to Custom Device 10.

    Select a value based on the imported configuration file. For example, if modbus_equip_custom_1.cfg is imported, select Custom Device 1.

    Port number

    Set this parameter to the number of the COM port connected to the custom device.


    Set this parameter to the communications address of the custom device.

  3. Set device monitoring parameters and click Submit.

    Figure 6-38 Device monitoring




    Running Info.

    View the running information about the custom device.



    View the device status, such as the switch status.



    View the real-time analog data of the device, such as the voltage.



    Set the status control parameters, such as the parameters for turning on or off switches.

    Set the parameters on the tab page as required.


    Set analog parameters, for example, set voltage protection parameters.

    Set the parameters on the tab page as required.

Updated: 2020-02-21

Document ID: EDOC1100108365

Views: 7327

Downloads: 1267

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next